Custom MIDI Captain Faceplates
Snap-on faceplates for the Paint Audio MIDI Captain. Your labels are printed into the plate, so they don't peel, smudge, or fall off mid-set.
Snap-on faceplates for the Paint Audio MIDI Captain. Your labels are printed into the plate, so they don't peel, smudge, or fall off mid-set.
Card statements show this as .
Your labels are part of the plate itself, not printed on top of it. Nothing to peel at the corners, smudge under a wet boot, or fade out after a season of gigging.
White on matte black is the standard combination — readable under stage wash, and legible at standing height.
The plate drops over the switches and grips the side edges of the chassis. No adhesive, no screws, no disassembly — and it comes off just as easily when you want to change your layout.
Cutouts clear the screen, the encoder, and every switch collar. The LED rings stay fully visible — nothing on the pedal is covered, dimmed, or harder to reach than it was before.
Every plate is made to order with your labels — nothing is pulled off a shelf and nothing is pre-printed.
Black with white labels is the standard. Custom colours are available on request, so ask before you order and it can usually be matched.
No two rigs are labelled the same way, so there is no standard set. You say what goes on each switch, and that's the plate you get.
Order first, then send your layout — a reply goes out with the order asking for it. Nothing is made until your labels are confirmed, so take your time getting them right.